How To Make An Induction Gun (Bolt Heater / Buster)

Link to wiring diagram & STL file for 3D printing the handle: https://drive.google.com/open?id=1b8q... Parts ordered from eBay. Use the following lines to search for the components I used in the video: "ZVS induction heater 1000w" - Induction heater with fan, 12-36VDC, 20A "Switch power supply 24v" - Power supply, output 24VDC, 33A "buck converter lm2596 adjustable" - Buck converter. Used to drop the voltage from 24v to 12v to drive the relay & LED "12v 40A relay" - Basic automotive style 12v relay (recommend buying a 24v relay because it would eliminate the need for the buck converter. Note: if doing the aforementioned replace the 1kohm LED resistor with a 2.2kohm resistor) "1/2watt metal film resistor" - (either 1kohm if using the 12v buck converter, OR 2.2kohm if running the LED directly from the 24v PSU) "push on-off latching switch" - basic latching switch "5mm LED mount bezel" - used to mount a 5mm led to the enclosure "5mm led red" - The LED I used was rated for 3.2~3.8v and a max current of 20ma "8GA wire" - Insulated 8gauge copper wire (I used about 3meters (or 10ft) total length) "c14 socket" - look for a C14 socket with an integrated fuse holder. "5mm fiberglass sleeving" - I bought sleeving with an internal diameter of 5mm. Buy about 2meters (6ft) worth (its cheap) "Split Conduit" - Split cable sleeving to fit over the 8GA cables that go to the handle (20mm or bigger dia, 1.5m long) "female spade terminal crimp yellow" - Used to connect the 8ga cable to the relay. "3 core mains cable" - I used less than 0.5m (1.5ft) rated for 240vac, 10amps "cable gland PG9" - quantity: 4 Optional: "5mm copper tube" - 5mm dia, 500mm long (1.5ft) I used this to make the 2nd smaller coil in the video Music: Say Yeah - Topher Mohr and Alex Elena:    • Say Yeah – Topher Mohr and Alex Elena (No ...   SCHEMATIX -