Scion TC or Toyota passenger side CV axle carrier bearing housing removal - Heat and PB Blaster

2006 Scion TC, 223k miles. CV boot on the passenger side finally busted after 223k miles. Here I swap the OEM carrier bearing housing from the old axle to a new Napa Axle using PB Blaster and Heat. I've seen/heard of others cut off the axle for a more manageable piece, pried or knocked out while still on the vehicle, pressed out with a hydraulic press, and also braced up against concrete and sledge hammered out. Here I soaked it in PB Blaster for about 20 minutes, then heated up the outside housing for about 1-2 minutes with a Bernzomatic until the PB blaster started boiling and caught on fire. To get it out, I held up the axle vertically and tapped down LIGHTLY against the housing edge until it eventually came off. I didn't have to remove the engine bracket, for the carrier housing. For the replacement axles I'm using NAPA - Premium CV Shafts Passenger Part # NCV 944031 Driver Part # NCV 944030 Limited Lifetime Warranty. I had a 20% off coupon and shipping was free to my door. $195 all-in for the L/R pair. #CVAxleRemoval #PassengerCVAxle #CarrierBearing