2021 Axis 500 grinding noise on deceleration. (One way bearing???)
Well here is another HiSun, Axis, Massismo, Bennche, ect... Clutch issues. THis unit only has about 225 miles on it & is driven with care by an older couple. Just goes to show that no matter who drives one of these are how easy you are on one that still just break due to cheap metals & everything else that is built in china. If you have any questions about motorcyles, atvs, utvs, leave a comment are you can find me on FB at Limitless Powersports service & repair are you can email me at [email protected]
▶︎
Hisun Strike, No Spark, No Fuel Pump, NO Diag Plug Power.
▶︎
Bennche 500, knocking & smoking motor diag Part#1
▶︎
2024 CAN-AM OUTLANDER DPS 700 - National Powersports Distributors
▶︎
Coleman Outfitter owner swapped out $2,000.00 worth of part & still didn't fix his issues.
▶︎
CVT Drive System
▶︎
WILL ALL GM 6.2 L87's FAIL? This one did @50K! Not Under Warranty? FULL ENGINE TEARDOWN!
▶︎
Powerful Prayer for Healing, Protection & Blessings for Your Home & Family
▶︎
Hisun Axis 500 Low Gear Shift Issue and Fix
▶︎
Impossible Thermostat! Cadillac SRX 3.6 Part 2
▶︎
Dealership Gave Up On This $15,000 UTV So I Got It Cheap
▶︎
Repairing a motherboard with a subtle intermittent fault
▶︎
Trying To SAve A Mouse Infested Prairie 300.
▶︎
Massimo T-Boss 550 Full Wet Clutch Replacement
▶︎
FULL BUILD: From Mazda B2500 to 550HP Supercharged Monster
▶︎
Dealership Gave Up On This $18,000 UTV Bought At Auction. How Bad Could It Be?
▶︎
Let's talk about wet clutch setup, adding slugs & the many issues we all have.
▶︎
My Johnson Needs An Overhaul, and it's Putting Up A Fight! Johnson Engine Part 3
▶︎
I EXPOSED BUGATTI'S SERVICE & REPAIR COST'S
▶︎
Bennche 500, Knocking & smoking motor part #2
▶︎