Armourer Works G18C Repair

Customer sent me an Armourer Works G18C that he wanted a few bits done to. Mainly a steel hammer mech installed and a new hop rubber. This was supposed to be a very easy and quick job. However, after fitting the steel hammer mech, I started seeing a full auto issue. I initially fixed this and sent it back to the customer but within a day of use, the full auto issue came back. Initially I thought the issue was the trigger bar or semi sear getting stuck. However after lots of investigation, it looks like the stripped screws in the slide and a loose blowback unit were causing the issue. Fully repaired and tested. Full steel hammer mech, new springs, new trigger bar, repaired front and rear sight. Shimmed selector plate to allow for reliable full and semi auto. It’s only a cheap pistol and he wasn’t planning on spending a lot of money on it, so where possible, I’ve used parts I already have in stock that cost almost nothing. The odd new screw and spring is pennies so thankfully he’s not had to buy any new parts. I ended up looking at this over the course of a few evenings, so I’ve cut out lots of the boring investigation. #airsoft #airsoftcqb #airsoftgun #gasblowback #toys #custom