Briggs and Stratton Power Built 12.5 HP Flathead Model 28 Rebuild, Teardown / Reassembly PART 1

PART 1.... In this video i'm doing a teardown and rebuild of a Briggs and Stratton Power Built 12.5 HP Flathead Model 28 Lawn Mower engine. Hope this series helps you, be sure to watch the other parts. And the last part is the first start of this motor after being rebuilt (not a complete break in video, just the first few minutes of running and adjusting carburetor) The only thing i left out was checking the ring gap clearance, which all you do is put a new ring in the cylinder use the piston to push it down about a half inch or so and use a feeler gauge to check the gap on the ring. Use general safety rules when doing anything like this, it is extremely to cut/smash fingers at any point. I cut my thumb really bad on the timing gear on the crankshaft (off camera). Just be careful and use common sense. Thanks for watching