Adding OSPF (Bird2) to your WireGuard Hub and Spoke Site-to-Site VPN
00:00 Introduction 00:47 What dynamic routing is 01:49 Why to use dynamic routing 04:17 Initial setup 04:51 HUB configuration IPv4 08:51 Spokes configuration IPv4 13:56 Configuration cleanup 15:46 Injecting routes to kernel 18:38 OSPF IPv6 setup 21:49 ECMP 26:02 Link failure
▶︎
Unlock the Power of Nftables: Mastering Destination Network Address Translation (DNAT)
▶︎
Multipath TCP Site-to-Site VPN (2x Bandwidth + Instant Failover)
▶︎
OSPF Network Types - FINALLY, an explanation that makes sense - Practical OSPF
▶︎
I Don't Think I Can Go Back To Windows...
▶︎
VLANs Explained | Full Configuration & Troubleshooting on Cisco Switches | CCNA
▶︎
Ultimate MikroTik Wireguard Site-to-Site Guide
▶︎
The ULTIMATE Guide to Enterprise Wi-Fi Security (HashiCorp Vault + EAP-TLS)
▶︎
Wireguard Nat-to-Nat (Hub and Spoke)
▶︎
ALL ABOUT VPNs in OPNsense! Wireguard, OpenVPN, and IPSec Setup and Configuration
▶︎
Don't Just Hide. Blend In. (Xray Routing Explained)
▶︎
Basic Site-to-Site VPN Using WireGuard and pfSense
▶︎
IPv8 is STUPID!! Why we can't just make IP addresses longer
▶︎
Trump Gets Booed & Falls Asleep During NBA Finals, Claims War is Almost Over & Goodbye Spencer Pratt
▶︎
USA vs Germany - ALL GOALS & Highlights | FIFA International Friendly 2026
▶︎
Best Fails of the Week 😂 Try Not to Laugh
▶︎
The Ultimate Guide to Linux Wi-Fi: WPA3, EAP-PEAP, and EAP-TLS
▶︎
How to Create a Site to Site VPN // OpenWrt, Wireguard
▶︎
Dynamic Routing with Wireguard, Optimize your MikroTik network!
▶︎
Automatic VPN Failover with Mikrotik: Implementing Redundancy with WireGuard and OSPF
▶︎