Process Multispectral & Thermal Drone (Altum) Imagery on Drone2Map - with ground control points

Step by step processing methods for creating orthomosaics, digital surface models (DSM), and digital terrain models (DTMs) on Drone2Map. Process multispectral and thermal imagery as separate projects for best results Video timeline Video introduction and processing steps 00:00 Formatting imagery before uploading to Drone2Map 04:50 Uploading data to Drone2Map 06:39 Defining cameras 09:54 Uploading ground control point (GCP) GPS data 14:26 Defining processing parameters 21:00 Viewing results and calculating vegetation index 23:40 Viewing processing report 29:10 Sensor: Micasense Altum Multispectral and Thermal Drone: DJI Matrice 200 Flight planning software: DJI Pilot Processing software: ESRI Drone2Map DISCLAIMER: Aerial imagery of aquatic systems, such as the one featured on this video, can be very challenging to process which leads to the poor orthomosaic generation over the water in this map as well as poor Processing Report values. This was acceptable for the purpose of this video, but imagery of terrestrial systems with poor stitching results could be due to poor sensor calibration or insufficient overlap. Please review the literature to ensure you collect the best imagery for monitoring your area of interest.