Сочный вазон/кашпо Апельсин из бетона (цемента) своими руками

Juicy and bright New Year's decor for the home. An orange flower pot with your own hands out of concrete, can be made from plaster to perfectly complement the New Year's atmosphere. ************************************************** **************** Vase "Watermelon":    • Сочная ваза/вазон из бетона. Украшения для...   Vase "Cactus":    • Ваза  "Кактус" из бетона/цемента своими ру...   Vase "Pumpkin":    • Чудесные вазы и горшки в форме тыквы 🌻 из ...   Vases of concrete (cement):    • Чудесные вазы и горшки в форме тыквы 🌻 из ...   ________________________________________________________________ Stages of work: 1. Nylon stocking at least 40 dan. 2. I mix 2 parts of sand, 1 part of cement, I add water. The solution should get thick. 3. Leave for 24 hours to set. 4. Sandpaper smooth edge. 5. Pick up a saucer of the right size. At the end of the video I will show my mistake with the saucer. It was necessary to put something on a saucer so that there was no fossa, but rather to make a small hill. 6. I have a silver poplar leaf, it has a beautiful texture and the leaf is very dense. 7. I grow alabaster and add some PVA for strength. 8. Very carefully trying not to go beyond the edges distribute the mixture. The minimum layer thickness at the edges is 3 mm. I insert a wire. 9. I make prints from the back side. 10. When frozen, the reaction will begin and the alabaster will heat up, give it time to cool for about 30 minutes and remove the sheet. I cut the stains with a knife, smooth the edge at an angle. 11. Apply putty, smooth with a wet hand and a sponge dipped in water and make a texture. 12. A piece of cotton tissue wetted in alabaster solution. 13. Glue with white glue. 14. I apply a dark green tone, dry a little and remove excess paint with a wet sponge, then a lighter tone and a little orange and yellow. All paints are acrylic. 15. Surplus paint blotting with a sponge. Then tinted a lighter shade. It turns out a real orange. 16. I coat with waterproof lacquer, I have parquet. Here is such a tasty and juicy pot! At the end of the video I will talk about my mistakes in my work. In this paper I have 2 errors: 1) The putty needs to be carried by a thin layer and evenly, I have a crack, and in this work you cannot hide it with paint, as the relief will disappear. 2. Something needs to be put on the saucer to make a small hill, respectively, there will be a depression on the sheet for the accumulation of water. I got a bulge on the sheet and the water will drain on the window sill. Friends do not repeat my mistakes! I wish you beautiful and interesting works! Good luck! Also on the channel you can find the master classes of these pots here, I'll leave the links under the video.