contrôleur webasto chinois - cdes usuelles - voir correctif dans détails

Controller information and programming of the two countdown timers, delayed start, and heating stop. Option to switch between selecting a setpoint temperature or a fuel pump flow rate. A correction! At 4:41 and 8:40 Two countdown timers are programmed: the first to indicate how long it will take for the heating to start after the programming is confirmed, and the second to indicate how long it will take for the heating to stop (from the programmed time), not the heating duration. 11/30/2022 As SYL BEL points out, at 5:40 I mention the current (which is coming out of the battery at that moment) in amp-hours, whereas it should be amps! Added 10/11/2020 After further consideration, although most people select the display of the set temperature (when you're in the van, it's the temperature inside that matters), there can be an advantage to choosing a pump flow rate. For example, if you want to keep your vehicle at a comfortable temperature for an extended period and what matters is managing the operating time based on the pump's capacity. reservoir. Prioritize heating time by selecting a P- xx Hz value. On the 2 kW model, the minimum consumption is approximately 0.1 l/h, so by selecting the minimum pump "flow rate," I'm confident the heater can run for about 45 hours. Temperature isn't my priority in this case; I just want to avoid it getting too cold. Perhaps I'll run some tests on consumption/duration based on the Hz value.