#583 NANOVNA Not all 50ohm loads are 50ohms
Episode 583 Using the VNA to measure frequency range of BNC 50ohm loads Short 50 ohm load perfect to 1GHz: https://www.ebay.com/itm/Low-Profile-... Be a Patron: / imsaiguy
▶︎
#593 SMA Load Improved and NanoVNA Measurements of Several Loads
▶︎
nanoVNA: Measuring the Input Impedance of a Filter (068c)
▶︎
#573c NANOVNA 1/4Wave Vertical Antenna Measurement
▶︎
#502 NANOVNA Demystified
▶︎
Setting up the NanoVNA for checking baluns and insertion losses
▶︎
#517 NANOVNA RF Demo Board
▶︎
The Technology We Killed in the 1960s Is Now Worth $3.3 Billion
▶︎
#78: Building VNA Calibration Loads
▶︎
This Battery Lasts for 30 Years And China Just Put It on the Grid
▶︎
EEVblog 1718 - Cheap 1GHz Oscilloscopes are Useless? ($5 DIY 1GHz Resistive Probe)
▶︎
#480 NANOVNA Made Simple
▶︎
437 How to Use a Vector Network Analyzer (VNA) to Test Antennas
▶︎
mechanical light bulb from 1675
▶︎
Most Hams Are Using the WRONG Toroidal Cores!
▶︎
#833 Impedance Test Fixture for the NanoVNA
▶︎
How to use a nanoVNA as a grid dip meter.
▶︎
Life on a Bismarck was Worse than Hell
▶︎
#337: Use a NanoVNA to measure input impedance and gain of a small-signal RF amplifier
▶︎
Germany’s Useless Answer to the Global Hawk
▶︎