3D printed climbing holds

A quick run through of how I 3D printed some holds for climbing/pull up practice. For the first two I use stls from thingyverse, the second two I draw in OpenSCAD. They didn't fail catastrophically! The 3D printed climbing holds were lots of fun and I can make shapes I couldn't buy, they probably won't last forever but on a pull-up board I won't fall far. Links for source stls: Pikachu By Davis Layman: https://www.thingiverse.com/thing:250... Everest by Whitney Potter: https://www.thingiverse.com/thing:220932 OpenCAD: https://www.openscad.org/ My OpenSCAD introduction: https://www.instructables.com/id/Open... Amazon affiliate links: Printer used: UK https://amzn.to/2NqqM55 US https://amzn.to/2NrIi9H PLA Filament used: White: UK https://amzn.to/327MXRN US https://amzn.to/2NqMTt0 Grey: UK https://amzn.to/2Myycn4 US https://amzn.to/30bbUiy Beige: UK https://amzn.to/2MyymLc US https://amzn.to/2LJ4XMW Music: Wide awake by the 126ers    • The 126ers - Wide Awake