Alat pelubang mulsa plastik

Published December 26, 2020 This simple plastic mulch perforator is very helpful for farmers because it only takes 10-15 minutes to make holes in a roll of mulch of various sizes and desired spacing. To make this plastic mulch perforator, the following materials are needed: 1. Several wooden blocks for the frame of the tool. 2. Several planks to make an octagonal wheel with a diameter of 50 cm and a length of 80 cm, each side 18.5 cm wide. 3. Two 1-meter-long iron rods serve as the axle for the octagonal wheel, and the other as the axle for the plastic mulch roll. These have been modified as shown in the video above. 4. Three polyurethanes of different sizes according to your needs. The small polyurethane is mounted on the dynamo, the medium-sized one on the axle for the plastic mulch roll, and the largest one on the axle of the octagonal wheel. 5. Four bearings, installed once on each side of the axle, are a great help for farmers, as they require minimal effort. In just 10-15 minutes, you can make holes in a roll of mulch of any size and desired spacing. A simple and very easy mulching tool. To make this mulching tool, you'll need the following materials: 1. Several wooden blocks for the frame. 2. Several planks to make an octagonal wheel with a diameter of 50 cm and a length of 80 cm, each side 18.5 cm wide. 3. Two 1-meter-long metal rods serve as the axle for the octagonal wheel, and the other as the axle for the mulching roll. These have been modified as shown in the video above. 4. Three polypropylene rods of varying sizes, as desired. The small polypropylene rod is mounted on the dynamometer, the medium-sized one is mounted on the axle for the mulching roll, and the largest one is mounted on the axle of the octagonal wheel. 5. Four bearings are installed on each side of the axle. 6. One drill with a modified drill bit depending on the desired size. Don't forget a ruler to measure the length and width of each hole. The desired size. Once the six materials are complete, we just need to assemble them according to the video above. After the assembly process is complete, we can try this tool. To make a hole in one roll of mulch, it only takes 10-15 minutes, so we need very little time. Therefore, this tool is very helpful for farmers. It is very efficient and practical. The cost to make this simple mulch plastic hole punching tool is very affordable, only around 3 million rupiah, which includes the drill, dynamo, and other things. For 3 million rupiah, we already have a mulch hole punching tool like this. If we accept hole punching services, here one roll costs around 35,000 rupiah. So this tool is very profitable if it becomes a business opportunity. Thank you. Good luck! If there is anything you still don't understand, please comment in the comments section. This concludes the explanation or description of this simple mulch plastic hole punching tool. If there are any errors in my words from beginning to end, I, as a representative of the Sahabat Tani TV channel, apologize profusely. I will end this with greetings. Mu'allaikum wr wb greetings to Indonesian farmers 🙏