Linuxcnc Bare Bones, Part 4 - PNCCONF Wizard
In this video, I go over the basic settings needed to get started with LinuxCNC and Mesa hardware using the PNCCONF wizard by "da man" himself, Mr. Chris Morley, as well as a few little useful tricks that you may find useful with the 7i76e/ed boards. Help support my coffee fund, if you feel generous :) / theferalengineer Additional information regarding pncconf can be found here: http://linuxcnc.org/docs/html/config/... I apologize for the length of the video. I will post timestamps shortly.
▶︎
LinuxCNC Bare Bones, Part 5 - Network setup and isolcpus
▶︎
LinuxCNC for the bare bones beginner - Part 1
▶︎
LinuxCNC HAL #1: The Basics
▶︎
Getting started with Mesa 7i96s: The perfect alternative to the 7i76e?
▶︎
LinuxCNC bare bones tutorial - part 2... 1.5, really
▶︎
Mesa 7i76E Overview & Single Ended vs Differential Mode Signals
▶︎
Top 5 Reasons to Use EtherCAT on Your Next CNC Build or Retrofit
▶︎
Türkei – USA Highlights | Gruppe D, FIFA WM 2026 | sportstudio
▶︎
Music for Work — Deep Focus Mix for Programming, Coding
▶︎
LinuxCNC Classicladder introduction tutorial
▶︎
LinuxCNC Bare Bones, Part 3 - STEPCONF wizard
▶︎
MIT Just Revealed the AI Bubble's Fatal Flaw
▶︎
We power up a giant Thyratron tube
▶︎
(LinuxCNC) Building a CNC from scratch. This might surprise you.
▶︎
GladeVCP Barebones V0.1 BETA
▶︎
Linux Full Course for Beginners | Learn Linux System Administration
▶︎
LinuxCNC User Interface Proposal
▶︎
LinuxCNC HAL #4: PyVCP
▶︎