3D-Drucke gezielt verstärken! Der Slicer-Trick mit Modifiern | Slicer Samstag #26

*🎓 3D Printing Academy: https://www.3dd-akademie.de – Become part of the community! *Discount code: Use the code "Lion" and save 10% on your membership permanently! Recommended Filaments: *PETG Filament: https://amzn.to/4sARA2k *PLA Filament: https://amzn.to/4vzZ5Jx 🚀 Why you shouldn't print your entire 3D part with rigidity! Do you want maximum stability for functional 3D prints, but are annoyed by extremely long print times and unnecessary material waste? 🛠️ In this video, I'll show you an ingenious slicer trick that allows you to reinforce only the areas that will actually be under stress! ⏱️ Chapters / Timestamps 00:00 Why you shouldn't print everything solid 00:47 The clever solution: Slicer modifiers explained 01:10 Direct help with 3D printing problems 01:45 Placing and correctly configuring modifiers in the slicer 04:46 Beware of potential errors: Infill vs. wall lines 07:17 3 important rules for using modifiers 08:39 Bonus tip: Preventing stripped screw holes 09:41 Summary: When this slicer trick is most worthwhile My Equipment 🛒 *My camera: Sony Alpha ZV-E10: https://amzn.to/420rxre 🛒 *My second camera: DJI Osmo Pocket 3: https://amzn.to/4r3y137 🛒 *My microphone: DJI Mic Mini: https://amzn.to/4hxctWC 📜 FTC DISCLAIMER: All links or discount codes marked with an asterisk (*) in my video descriptions are affiliate links. This means I receive a small commission on any purchases you make through these links. There are no additional costs for you; it's simply another way to support me and my channel! :-)