Самостоятельная чистка и обучение дроссельной заслонки на примере Nissan Almera

People write that this procedure works for many cars, for example, the Lada Granta. If you just need to train the throttle body, click this link and follow all the steps I did at 2:38 PM. If you're having trouble, try immediately releasing the pedal at the end when the check engine light comes on, rather than holding it for 3 seconds. Qashqai drivers also have a description for training the pedal and training the throttle body to supply air at idle speed before training the throttle body. 1. Training the pedal: — Without pressing the gas pedal, turn the ignition on for 2 seconds. — Turn the ignition off and wait 10 seconds. — Without pressing the gas pedal, turn the ignition on for 2 seconds. — Turn the ignition off and wait 10 seconds. P.S. Do not start the engine. 2. Throttle body air flow training at idle: — Without pressing the accelerator pedal, turn on the ignition. — Turn off the ignition. — If the throttle body "buzzes" within the next 10 seconds, everything has been done correctly. 3. Before starting idle speed training, perform the following preparations: — Make sure the battery voltage is at least 12.9V (at idle speed), the transmission is fully warmed up, and the engine coolant temperature is 70-100°C. — ​​Shift the gear selector to position "P." — Turn off all electrical loads (headlights, air conditioning, radio, rear window defroster). — Set the steering wheel straight. If any of these conditions are not met, idle speed training will not occur. A stopwatch is required for further steps. Further follow my video. 4. Idle Speed ​​Training — Train the pedal. — Perform throttle body learning to supply air at idle speed. — Start the engine and warm it up to normal operating temperature. — Turn the ignition off for 10 seconds. — Without pressing the accelerator pedal, turn the ignition on for 3 seconds. — Press and release the accelerator pedal 5 times within the next 5 seconds. — Seven seconds after the last press, press the accelerator pedal for another 20 seconds until the MI indicator lights up continuously. — Fully release the pedal within 3 seconds after the indicator stops flashing. — Run the engine at idle for 20 seconds. Nissan Almera N16, 2005, manual transmission, QG15DE. According to the manual, the normal idle speed should be: 700 plus or minus 50 on a manual 800 plus or minus 50 on an automatic About 1200-1300 on a cold engine **************************************************** Channel 2 - http://bit.ly/2aoYZj5 (support by subscribing) Instagram:   / andrreiiii   I'm on VK - https://vk.com/andrreii (better to write a private message than in the comments) I'm on Drive - http://www.drive2.ru/users/anriblog/ Email 1: [email protected] (For commercial inquiries) Email 2: [email protected] (Just questions) ***************************** I'd like to ask you to support me. Follow the link to my channel on Yandex Zen - dzen.ru/kuvshinov - just click to subscribe and that's it. Thank you from the bottom of my heart! Hugged, held, spun, and put me back in my place.