Floating Oak Plywood Entertainment Unit

PLANS AVAILABLE HERE: https://gum.co/IGvmH For this project I wanted a clean, minimal entertainment unit to go on our feature wall and bring focus to the material rather than the design of the piece itself. I used Oak veneer birch plywood which has a super clean grain so I decided to make the front panel one long piece instead of 3 separate panels. There is a good amount of storage for devices and I have run HDMI cables through the wall from the TV to inside the unit so there are no visible cables. I also used the bristles from a draught stopper that goes on doors to give a clean cable entry for the soundbar on top that sits on top of the unit. I used french cleats to hang it onto the walls. Luckily I had a lot of studs in the wall so mounting it was quite easy and it turned out a lot stronger than I expected. Oak plywood from Plytech:http://www.plytech.co.nz/ Fall flap hinges: https://www.fit-nz.co.nz/drawer-and-d... _______________________________________________ My Tools: Dewalt table saw: https://amzn.to/3ackejR Countersink bit: https://amzn.to/33KaXOK Music/Ear protection: https://amzn.to/3fKEb2l Camera: https://amzn.to/31P9sfN Makita track saw: https://amzn.to/3D7QXVp Router: https://amzn.to/2PFz5tu Pocket hole jig: https://amzn.to/3a9E3s0 Mechanical pencil: https://amzn.to/3acH9LH CA Glue: https://amzn.to/2NvFE49 (Get 15% off using promo code "OFFCUT15" at https://www.starbond.com/?rfsn=296018...) _______________________________________________ Get my plans: https://gumroad.com/theoffcut Instagram:   / theoffcut_nz   Facebook:   / theoffcut   Buy me a coffee: https://www.buymeacoffee.com/theoffcut Support me on Patreon:   / theoffcut