【 SG2粉末鋼刀刃修復 】崩刃要按這步驟修復｜MIYABI5000 ｜打掉重磨 | 用微距檢查刀刃｜自己弄壞自己修

I always say that after using a knife, you should wash it, dry it, and put it away without hesitation. This is because I have a painful experience—it hurts even more than cutting my hand. Once, after using a knife, I didn't put it away properly; I placed a cast iron pot next to it, pressing down on the entire blade. The result was horrific. My MIYABI 5000MCD's entire blade was severely damaged, and today I'm going to have it scrapped and resharpened! Facebook →   / christable1613   Instagram →   / chris_table1613   ------------------------------------------------------------- Shooting Equipment List Panasonic Lumix S5M2 Panasonic Lumix G9 Panasonic Lumix LUMIX S 24-105mm F4 G 25mm F1.7 G 14mm F2.5 G 42.5mm f1.7 FUJIFILM XH-2 FUJIFILM XF23mmF1.4 R LM WR Yongno YN600ll Yongno YN360ll Aputure Amaran 200X RodeVideoMicNTG Dji mic2 9.solutions C-pan Arm ii PNG designed by https://zh.pngtree.com 00:00 Blade Damage Condition 02:10 Whetstone Introduction 04:19 Workflow 05:23 Pre-Repair Test 05:57 ATOMA 140-grind flat edge line 07:16 Habashi 320-grind flat edge line 08:06 ATOMA 140-grind secondary edge 09:10 Habashi 320-grind secondary edge 09:57 Drilling 1000-grind secondary edge finishing 10:16 Habashi 5000-grind secondary edge finishing 10:40 Habashi 320-grind main edge reconstruction 11:14 Drilling 1000-grind main edge grinding 11:41 Drilling 3000-grind main edge grinding 12:07 Habashi 5000-grind main edge grinding 12:46 Habashi 12000-grind main edge grinding 13:23 Finishing with blade polishing + final test