Wr400 1998 The correct process to starting (THIS WILL START YOUR BIKE)

WR400f 1998 (NOT YZ like I say) My mistake i had YZ on my mind. If you do follow this procedure you will be able to start your bike if it is properly tuned! here it is in step by step. Step1 Turn on fuel, Step2 Pull choke out and two full revs if bike hasn't been started in 24-48hrs Step3 Lower kick start until you find hard compression point(this is where you cant push down as its now to hard to move) Step4 Still holding slight pressure on kick starter pull decompression lever in and now press down on kick starter (ONLY 25-50mm VERY IMPORTANT) Step5 Release decomp lever and raise kick starter top top Step6 Kick now to start but do not use throttle as you primed the engine in step2 Once started run for 20 sec and press choke back in HAVE FUN