COMO FAZER UM SUPORTE PARA MICROFONE PRÁTICO E ESTILOSO | TAMBÉM SERVE EM CÂMERAS

Or to your camera. Or a lampshade, whatever. Here's another DIY to turn your room into a nasty dirty place. This is a simple project but it has the potential to be difficult due to trick cuts will be needed to make in wood parts. All the parts as listed below, including some tool suggestions. Good luck! - - BILL OF MATERIAL 2x carriage bolt 5” x 5/16”; 1x carriage bolt de 2½” x 5/16" 2x washer 1½” x 3/8”; 3x wing nut 5/16”; 1x hex bolt 1¼” x 1/4” - 20 UNC (camera thread); 1x hex nut 1¼” x 1/4” - 20 UNC (camera thread); 1x wood screw approx. 3,5 x 16 mm; 1x single bent shovel handle 1½” (38 mm); 1x curtain rod 3/4” approx. 1,20 m long; 1x wood block 10 x 15 x 5 cm; 4x rod end-cap 3/4”. SUGGESTED TOOLS Saw, Japanese saw, jig-saw, tape saw; Hacksaw; Superglue of any craft glue; Cordless screwdriver or speed control drill; Countersink drill bit M8; Steel stretch shank drill bits 6 and 8 mm; Wood twist drill bit 8 mm; Wood flat or Fostner drill bit 3/4”; Phillips screwdriver PH2; Sandpaper 80 and 120 or 320 grit. - - Project PDF: http://bit.ly/BracoArticulado - - Songs Creative Commons 4.0 Golden Duck Orchestra - 06 - Mix it Up Doctor Turtle - 07 - I Snost I Lost - - HOW TO MAKE A MIC TABLE STAND    • COMO FAZER UM SUPORTE PARA MICROFONE PRÁTI...