Rb25det neo aftermarket intake manifold install

in this video i go over how i installed my manifold. you see alot of these on higher hp rb motors but majority of them come with little to no installation instructions. although there were 2 thinks i havent yet figured out if i find a solution ill add it to the dec or comments. enjoy -Second treaded spot on coolant lines is for another coolant sensor same thread pitch this is for the "coolant switch" but can fit aftermarket coolant temp sensors for guages just confirmed its the other sensor for tps 1. Remove the extension plate i left on the throttle, there is a T8 allen key holding it in 2. Take the small disk plate with the half moon hole and put it on the shaft 3. Mount the tps bracket 4.mount the other sensor to the bracket (this sensor has a pigtale with 2 plugs)