Design Procedure of Knuckle Joint, Design of Machine Element, Types of Failures | Shubham Kola

In todays session will learn about design procedure for knuckle joint, this type of joint is used for tensile application were we join two rods which are acted by tensile load. Timecodes 0:00 - Design Procedure for Knuckle Joint 0:03 - Application of Knuckle Joint 0:09 - Parts 0:35 - Dimensions 0:52 - Types of Failures in Knuckle Joint 1:05 - Tensile stress at diameter of rod 1:18 - Tensile stress at outside diameter of single eye 1:30 - Tensile stress at outside diameter of double eye 1:43 - Double shear stress at diameter of knuckle pin 1:55 - Double shear stress at outside diameter of single eye 2:07 - Double shear stress at outside diameter of double eye 2:21 - Crushing stress at thickness of single eye 2:31 - Crushing stress at thickness of double eye #Design_Procedure_of_Knuckle_Joint #Knuckle_Joint_assembly_drawing #Design_of_Machine_element #Knuckle_Joint This Video Topic is from Design of Machine Element Subject, you can also watch below mentioned video related to Design of Machine Element Subject: Design Procedure of Cotter Joint -    • Design Procedure of Cotter Joint, Design o...   Don’t Forget To Like , Comment , Share & Subscribe [ THANKS FOR WATCHING THIS VIDEO ] Faculty - Shubham Kola Email ID - [email protected] From - Maharashtra ( India ) YouTube Channel ( Shubham Kola ) -    / @ifinfotech   Disclaimer - video is for educational purpose only. Copyright Disclaimer Under Section 107 of the Copyright Act 1976, allowance is made for "fair use" for purposes such as criticism, comment, news reporting, teaching, scholarship, and research. Fair use is a use permitted by copyright statute that might otherwise be infringing. Non-profit, educational or personal use tips the balance in favour of fair use. The content in this video is collected from books, media, internet space etc. This is strictly for educational and information purposes and is not intended to be advice or recommendation of any kind whatsoever. The faculty is not a subject expert. The faculty is sharing his knowledge in the form of videos. The faculty giving small basics information on mechanical engineering topics. We endeavour to keep the information up to date and correct, we make no representations or warranties of any kind, express or implied, about the completeness, accuracy, reliability, suitability or availability with respect to the video or the information, related graphics contained in the video for any purpose. any reliance you place on such information is therefore strictly at your own risk. In no event will we be liable for any loss or damage without limitation, indirect or consequential loss or damage, or any loss or damage whatsoever arising from loss of data or profits arise out of, or in connection with, the use of this video.