Pocket NC Impeller Part 1 - Fusion 360 Geometry
This video is the first part of a 3 part series teaching Pocket NC users how to create a wooden impeller from start to finish. This video describes setting up the geometry in Fusion 360. For the Fusion 360 table and vise file go here: http://a360.co/21mUm81 For the Fusion 360 impeller model go here: http://a360.co/1ZBO1GL
▶︎
Pocket NC Impeller Part 2 - Fusion 360 Toolpaths
▶︎
Pocket NC Impeller Part 3 - Machining
▶︎
How To Model a Turbo Compressor/Impeller | Fusion 360 Tutorial
▶︎
Fusion Ultimate Swarf 5 Axis Toolpath - Tutorial 1 of 2
▶︎
Why Trains ALWAYS Run an EMPTY Car
▶︎
PocketNC V2 3+2 5-Axis ...Face Scan
▶︎
In 2007, Elon Musk Predicted Everything (Rare Lost Interview)
▶︎
Engraving a key with Pocket NC
▶︎
People Who Messed With The Royal Guard and Regretted It!
▶︎
Pocket NC V2 - Facing 5 materials including stainless steel
▶︎
Most Ridiculous Worker Mistakes Caught on Camera
▶︎
Tutorial: Using FLOW TOOLPATH in Fusion 360 | FF126
▶︎
Es gibt etwas, das schneller ist als Licht | Richard Feynman
▶︎
Making hold-down clamps on PocketNC
▶︎
Incredible Street Performers – Caught on Camera
▶︎
Pocket NC V2 5-axis Fusion 360 Flow toolpath
▶︎
Worst Plane Landing Fails Caught on Camera
▶︎
PocketNC CAM Setup Tutorial
▶︎