Carhifi-Anlage richtige Sicherung |Tutorial | ARS24

I'm interested in how to fuse two amplifiers. I have one amplifier in the trunk for the front system with 4 x 120 watts at 4 ohms and one for the subwoofer with 1 x 800 watts RMS at 1 ohm. Currently, both amplifiers are connected to the battery in the engine compartment via a 20 mm² cable. I want to power both amplifiers with a thick 50 mm² power cable. I currently have an 80 amp fuse for each amplifier. Here's a link to various fuses and fuse holders in our webshop: https://www.ars24.com/zubehoer/sicher... All videos at a glance: https://videos.ars24.com/ You can route the basic power supply all the way to the trunk using a thick power cable with approximately 50 mm² wiring. This thick 50 mm² cable must be protected with a large ANL fuse no later than 30 cm after the battery terminal. Our recommendation is the following article: https://www.ars24.com/zubehoer/sicher... In this case, I would suggest a 200A fuse size. In the trunk, you can install a fuse distributor, for example, https://www.ars24.com/zubehoer/sicher..., which allows you to protect the sub-distribution board with mini ANL fuses. To do this, you protect the 20qmm cable with an 80 amp fuse. I definitely don't recommend the large glass tube fuses if you value quality. The ground cable can also be screwed onto the seat belt screw in the trunk without a distributor using a 20qmm power cable. Please always ensure that the crimp ring terminals at the cable end are always properly crimped. A 50 mm² power cable can be protected with up to 300 A. A 35 mm² power cable can be protected with up to 200 A. A 20 mm² power cable can be protected with up to 150 A. A 10 mm² power cable can be protected with up to 80 A. You can take a look at the accessories category in our online shop to see all the great fuse holders we have. We hope you enjoy crafting with it.