Wiring your first Pixel Controller, Pixels & Power Supply #Pixels #HolidayLighting #Baldrick

In this video we run through the basic wiring of a set of pixels, a Baldrick controller and a Meanwell RSP-320-12 12v Power Supply. We hook them all up detailing what we’re doing and why and run a test mode on the pixels at the end of the video. Let us know what you thought of the video, you can leave a comment (or SuperChat) below or buy us a coffee to help support the channel: https://ko-fi.com/gregmacaree This video has not been sponsored, but iLightThat did supply the Baldrick board at no cost and I do not have to return it. Baldrick Boards & Power Supplies available from: Austraila: Hanson Electronics: https://www.hansonelectronics.com.au/ Europe: Pro Pixeler: https://propixeler.nl/ USA: Gilbert Engineering USA: https://gilbertengineeringusa.com/ Wired Watts: https://www.wiredwatts.com/ UK: Build A Light Show: https://buildalightshow.com/ Affiliate Links to products used (I do get a small return from products purchased using these links): Amazon.com (USA) Workpro Style Scissors: https://amzn.to/42IgyUh 10 AWG Teflon Wire: https://amzn.to/4hRUwmr IEC Mains Cable (Various Lengths): https://amzn.to/3WScSvo Amazon.co.uk (UK) WorkPro Scissors: https://amzn.to/4aRvZLL 10AWG Teflon Wire: https://amzn.to/4jSUJaw Pro-Elec IEC Cable (2m): https://amzn.to/40XWg6S Timeline: 0:00 Introduction 0:52 Connecting Pixels to Controller 5:13 Wiring Phoenix Connector 10:52 Connecting Controller to Power Supply 14:26 Forks & Ferrules 20:12 Power Supply to Mains (110v or 220v) 24:04 LRS-350 Input Voltage Switch 24:24 Review Connections before plugging in! 25:10 Ethernet Connection 27:05 Plugging In 28:10 PC Connecting to Baldrick 29:30 Setup Output 30:27 Start Tests! 31:06 Reset Config & Retest! 32:00 Review what’s been covered in the video 35:00 Wrap-Up!