Citroen DS3 1.6 e-HDI FULL Service Oil Air Fuel Cabin Filter How To DIY Includes Service Light Reset

Here is the full service on the Citroen DS3 1.6 e-HDI diesel model years 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, and 2017. If this video helps then please support me by subscribing and liking the video, thank you! Quinton Hazell Parts used: Air filter: QFA0296 (WIX WA9663) Oil filter: QFL0064 (WIX WL7305) Fuel filter: QFF0356 (WIX WF8460) Cabin filter: QFC0313 Sump plug size is 21mm, torque requirement 34Nm Oil filter housing 27mm, torque requirement 25Nm Air filter: There are 3 T25 Torx screws along the front and a metal clip on the side that is easily done by hand. Make sure when fitting the new filter that the edges of the filter are definitely seated correctly. Fuel Filter: Remove the soundproof material on top of the engine. The fuel filter is located to the left hand side of the airbox/intake. Remove all the hoses and the electrical connector. There are 2x 8mm bolts at the rear and this will allow the top and filter to be removed from the car. Once you have removed the filter complete with the top if you lift the centre part by twisting this will allow the filter to be drained. Now remove the 3 T15 Torx screws. Now fit the top to the new filter making sure you replace the seal and fit completely square as the seal is easily dislodged. Push the centre down and replace the Torx screws. You can now refit to the car take care the bottom of the filter seats correctly, replace the hoses and electrical connector. Tighten the 8mm bolts. Cycle the ignition a few times as on a lot of cars this will allow the pre-delivery pump to fill the new filter. Now start the car and leave running for 5 minutes to make sure there's definitely no air.