Remove A Pillar And Install Chrysler 300 Dodge Charger EASY

Removing and replacing the front A-Pillar trim cover on a Chrysler 300, Dodge, and Jeep 🚘 vehicle is easy and should take under 15 ⏳ minutes to remove and reinstall both sides. Please SUBSCRIBE 🔔 if this helps, and click on SHOW MORE to see detailed guide and tools to use. 👉👉👉 Only Tool 🔧 needed is a: Flat tip screwdriver or pry bar: https://amzn.to/3eiB9mG Step 1: Start off by using your fingers or a prying piece to pull back the A pillar trim panel. Step 2: Once you pull it back a little bit, squeeze the black clip located towards the top of the pillar from the inside. Then wiggle it out. TO INSTALL: Step 3: Place the clip onto the pillar bracket area. Step 4: Line up the A-Pillar and snap it into place. It really is as easy as it seems, and shouldn't cost you anything if along if you have basic tools and a good set of fingers. If this video helped you please 👍 and SUBSCRIBE and/or make videos you think may help others. Or you can help support this channel and buy me a cup of coffee here ☕: ➡️https://www.buymeacoffee.com/randomca... OR ➡️ https://ko-fi.com/fixcaryourself Thanks and always keep learning and saving money by doing repairs yourself! 👍 Please LIKE 👍 👍 👍 AND SUBSCRIBE 🔔