Milwaukee Gen 4 vs DeWalt DCF860: The 264° Impact Driver Meltdown!

You asked for the ultimate rematch, and we delivered. In our previous video, we tested the hydraulic drivers, and many of you said the DeWalt DCF860 was the real competitor for the Milwaukee Gen 4. So, we listened. We put the DeWALT 20V MAX XR 1/4 in. 3-Speed Brushless High Torque Impact Driver (DCF860B) up against the Milwaukee M18 FUEL 1/4" Hex Impact Driver (2953-20) in one of the most violent tool tests we've ever done. We pushed these flagship impact drivers to the absolute limit driving 6-inch lag fasteners and boring 100 holes through 2x12 lumber using massive 1.5" spade bits. What happened? A classic battle of Power vs. Protection. One tool constantly went into thermal shutdown to save itself, while the other pushed through the pain until the outer coating literally sizzled and melted off at a staggering 264°F! 📺 WATCH NEXT: If you missed the controversial video that started this rivalry, watch the Hydraulic Torture Test here: Milwaukee vs DeWALT Hydraulic Impact Torture Test: One Cooked, One Quit! 👉    • Milwaukee vs DeWALT Hydraulic Impact Tortu...   In This Video: 0:00 - The Rematch You Asked For 0:38 - Tool Specs: RPMs vs Impacts Per Minute 1:30 - The 6" Lag Bolt Test (No Pilot Holes!) 8:05 - The 1.5" Spade Bit Torture Test Begins 10:18 - DeWalt DCF860 Thermal Shutdowns Start 20:07 - Round 2: Back to Driving Lag Bolts 34:07 - 100 Holes! The 264° Milwaukee Meltdown 36:28 - Final Thoughts: Power vs. Protection Let us know in the comments: are you choosing the DeWalt for its smart thermal protection, or the Milwaukee for its unstoppable brute force? 👇 Don't forget to SUBSCRIBE for more brutal Tool Test Raw videos! 👇 #MilwaukeeGen4 #DeWaltDCF860 #ToolTestRaw #ImpactDriverReview #MilwaukeeTool #DeWaltXR #PowerToolMeltdown