Bush Engineering - Ep07 - Making a roll bar for the backhoe
This month we built a DIY ROPS for the backhoe in the middle of the bush, it was hard work but with the help of some friends we ended up with a much safer rig. These old tractors have a tendency to roll and while we're pushing through uneven ground and pulling up tree stumps we need to make sure that we have a decent rollover bar for the old Ford.
▶︎
Into The Woods - Ep08 - DIY land clearing
▶︎
Massey Ferguson Roll Over Bars, Sheep, Pigs and Grass. |S2 E26
▶︎
Our biggest month yet - Ep38
▶︎
Inside the T-34-85
▶︎
Cutting and splitting a MASSIVE tree on our farm
▶︎
Truss the process - Ep39
▶︎
Unbelievable Smart Worker & Hilarious Fails | Construction Compilation #7 #adamrose #smartworkers
▶︎
How to Find a ROPS and How it Could Save Your Life
▶︎
Plumb job - Ep37
▶︎
Aussie School Bus Conversion - Ep01 - Brad and Luce's project so far
▶︎
#238 Case 430 - Homemade ROPS
▶︎
Dangerous Grindstone Installation in 1971
▶︎
Forest Road Works, Plus New Machine!
▶︎
Something is jamming GPS over Europe. Here's what we found
▶︎
Whitworths 1862 Slotting Machine
▶︎
installing an Iron Bull ROPS & canopy on the International 656 tractor
▶︎
Trump Autopens the Iran Deal, Lands a Res at G7 Summit & Spawns an Algae Conspiracy | The Daily Show
▶︎
The *WORST MISTAKE* a new tractor owner can make (modding ROPS)
▶︎
Including the kitchen sink - Ep36
▶︎