Reset Strain Gauge & Angle Sensor on Manitou Telehandlers

Works for telehandler 4-10m Safety checks: Stable load, tyre pressure correct and flat, level ground 1. Push parachute button 2. Within 10 seconds – hold down suspended load and test button 3. Turn on the machine 4. Make sure the boom is at its lowest and all the way in 5. Check the parking brake is on and wheels are aligned 6. Press the test button – green icon should appear on screen 7. Lift up the boom to its full height and press the test button, ensure the boom is still all the way in. 8. Turn the machine onto maximum revs 9. Lower the boom as fast as possible and then press the test button again 10. Make sure the boom it at its lowest and all the way in 11. Press test button 12. Hold parachute button while operating machine to pick the load up 13. Once headstock has locked onto the carriage, place your fork bar and pin into the headstock 14. Lift the load just off the floor 15. Push the boom out until the machine tips 16. Wait 5 seconds to make sure the machine is stable 17. Press test button – strain gauge should be set 18. Bring the boom in and check operation