SYIL X7 Basics: Calibrate the TTC-200 Tool Setter
This video is in response to a viewer's question. How did I calibrate my tool setter? In this video, I demonstrate using a master tool to calibrate the TTC-200. I also show how to measure the diameter and length of a tool. Links Fusion 360 Post Processor https://www.betztechnik.ca/store/p55/... 00:00 - Intro 02:08 - When Should you Calibrate? 03:59 - Calibration Framework 04:57 - Measuring the Master Tool 13:33 - Tool Setter Length Calibration 17:19 - Diameter Calibration 20:12 - How to Measure the Diameter of a Tool 26:30 - How to Measure the Length of a Tool 30:22 - Using Fusion 360 with the SYIL X7 34:35 - Conclusion
▶︎
Why I Walked Away From Xometry After Just One Year – My Honest Story
▶︎
Installing the Pioneer Touch Probe on the Syil X7 Part one.
▶︎
SYIL X7 Basics: Calibrate the Pioneer OP-510 Probe
▶︎
Calibrating the Pioneer TTC-200 tool probe on the Syil X7 with Siemens 808D control
▶︎
$40K CNC Lathe? First Look at the SYIL L2
▶︎
How Maxwell's Equations Were Discovered
▶︎
Maximizing Work Envelope by Machining Removable Tool Setter
▶︎
The Ten-Engine Titan: Inside the B-36 Peacemaker, The Cold War’s Largest Bomber
▶︎
Replacing Renishaw Probe Stylus, Tool Tuesday Ep.15
▶︎
The 90-Degree Torque Problem
▶︎
The Pressure was On for this Urgent CAT 637 Cylinder Rebuild
▶︎
Syil X7 Touch Probe Calibration
▶︎
Why We Chose SYIL CNC Machine Tools
▶︎
Unbelievable Smart Worker & Hilarious Fails | Construction Compilation #8 #adamrose #smartworkers
▶︎
A quick and easy way to set the tool height on your lathe using only basic tools.
▶︎
Setup and Initial Calibration of a Renishaw Tool Setter
▶︎
SyilX7 + Syntec 22Ma new tool setter screens, calibration, and How To Use.
▶︎
How We Thread 30ft Drill Rods (Wild Megabore Setup!)
▶︎
Accurate? Pioneer OP510 Probe (Real Data)
▶︎