Geared scooter hub motor repair, Warning about a cooling mod.
A geared scooter hub motor taken from a powerful scooter makes a clunking noise, probably caused by drilling holes in the motor casing for cooling. Holes can cause problems with gravel entering and destroying the planetary gears or even the stator.
▶︎
Fixing up an old ebike hub motor with water damage, shot bearings, and a broken hall sensor
▶︎
How to replace a damaged cable harness in an ebike hub motor
▶︎
Ebike Geared Hub Motor Repair: Loud Motor & Loose Magnets (Wired Freedom/Cruiser)
▶︎
How to Replace a Damaged Hall Sensor in an Ebike Hub Motor
▶︎
Minarelli Scooter Over Range Rear Pulley Alternatives Project 1of3
▶︎
Why Hub Motors are Better than Mid Drive Motors
▶︎
Toothless Gears Make Much More Torque Than Conventional Ones, Here's How. Cycloid Drive Explained
▶︎
Before You Trash Your Old PC Power Supply... Build This!
▶︎
Electric Scooter Hub Motor DIY Repair - replacing wires and bearing, cleaning rust
▶︎
Bafang Mid-Drive Motor EXPERT Reveals 1000 Mile Maintenance Secrets
▶︎
Sparta/Batavus Hub motor rework to use standard battery/motor controller.
▶︎
HORROR STORY BAFANG 750w Rear Hub Motor Repair - Part 2 (RUSTY)
▶︎
Understanding Everything about Hub Motor Drive Systems - Spezi 2020 Live Presentation
▶︎
My Oval Engine Now Fires At Will! Major Milestone For DIY Oval Rotary Engine 2.0
▶︎
60v E300 Hub Motor Scooter Conversion
▶︎
FULL Ebike Hub Repair Teardown And Rebuild! - Changing the axle on my Ebike hub motor
▶︎
Convert Alternator to Brushless Motor
▶︎
Satisfying Videos of Workers Doing Their Job Perfectly & Hilarious Fails #1 #fail #construction
▶︎
Replacing hub motor gears - FULL HOW TO GUIDE (BAFANG)
▶︎