Know your options! Parkside PDSSAP B2 B3 C3 20V anvil CONVERSION. Pick your favourite. ft. PPDSSA

FULL CONVERSION TUTORIAL:    • Video   Link for 16mm shaft anvil with 1/4” hex opening and 1\2” square drive (OPTION A) - https://www.aliexpress.com/item/10050... Link for 16mm shaft anvil with ONLY 1/2” square drive - https://www.ebay.com/itm/314845033182 Link for 10x16x22 steel bushing - https://www.aliexpress.com/item/10050... Link for 10x16x22 needle roller bearing - https://www.aliexpress.com/item/33008... Link for 10x16x22 graphite self lubricating brass bushing - https://www.aliexpress.com/item/33000... Link for 18mm shaft anvils 2PCS with and without 1/4” hex opening and with 1/2” square drive - https://www.ebay.com/itm/314222885310 Link for 20x16x22 steel bushing (would need machining see community page for measurements) - https://www.ebay.com/itm/204537622056 Link for 20x16x22 brass graphite self lubricating bushing (would need machining), here you will also find an 18x22x10 and 18x22x20 (would need machining) bushings for use with the 18mm anvils - https://www.ebay.com/itm/266386460600 Link for Id=8 / Od=10 bushing you would need to use at the bottom of the anvil in case you go with the 18mm shaft anvil. Please be aware you will also need to drill in to the anvil. Just in case I would buy a longer bushing and cut it down to size. So 10mm or so. - https://www.ebay.com/itm/266386268370 For the bushings that are 20mm in height. 10mm of them stay at the OD=22 and the other 10mm are machined down to OD=20mm. Please see the attached picture on the community page of this channel. *I have not found a suitable needle roller bearing for the 18mm anvils. However even for the 16mm anvils I have never tried this instead of a bushing. Despite the claims in many sellers descriptions I feel this is not up to the task! I am only including it as an alternative and if someone wants to try it! They know it is an option.