How to make a Cold Smoke Generator for your UDS or Smokehouse. Thin Blue Smoke Generator

Make a cold smoke generator DC brushless blower 120mm x 120mm x 32mm 32mm x 1.5m stainless silencer perforated baffle tube 150mm x 150mm 5mm square hole x 1.5mm thick Stainless perforated sheet 125mm dia x 1m long stainless flue pipe Stainless flue pipe cap Steel 11mm Diameter pipe @ 11.5cm long total - 8.5cm long from the inside of the 15mm copper pipe connector 1 x 28mm Munson ring 27mm long copper pipe extension (soldered into the nipple end - add a few mm to set in side) 28mm copper pipe into drum 77cm long 'total' 407mm (16”) 3/4 malleable iron pipe 4 x 3/4” male to male connectors - one for the perforated pipe - one for combustion outlet - two for the jar connection 2 x 3/4” male to male barrel connectors - one for the 28mm copper to the tee 2 x 3/4” tees 1 x 3/4” nipple end - for the 15mm @ 27mm long Venturi inlet 1 x 3/4” female to female connector - for the internal perforated pipe 3 x 3/4” nuts - two for the jars - one for the combustion outlet 1 x 22mm full bore compression valve 2 x jars (I used peanut butter jars) 1 x Hammond die cast box No 1590 1 x stainless paint kettle for the base of the hopper - this coincidental fitted the UK 5” flue pipe - you might have to adapt for your country