Dnepr Getriebe - Teil 9, Zusammenbau / Dnepr Transmission - part 9, assembling

Repair and optimization of the Dnepr gearbox with reverse gear. Part 9 - Assembling the Transmission Dnepr Transmission Repair and Improvement Part 9 - Assembling the Transmission In this video, I installed the following components, in addition to the transmission parts: O-rings (inner diameter x cross section) 2 x 6x2mm for the additional grooves on the reverse gear selector shaft 1 x 9x2.5mm for the original seal 1 x 17x3mm for the starter shaft countershaft Standard parts: 1 x 4x20mm dowel pin for securing the reverse gear selector shaft 2 x M6x16 countersunk head screws with hexagon socket for the selector shaft countershaft 9 x M6x40 hexagon screws + washer 1 x M6x10 hexagon screw 1 x M8x1 fine thread nut + washer + spring washer for the reverse gear selector shaft 1 x M8x1 castle nut + washer + 2mm cotter pin for selector shaft Sealants: Loctite 574 if no paper gasket is used (alternatively, Loctite 573 if a paper gasket is used, apply a thin layer to both sides) Hylomar H for additional sealing of the starter shaft counterbearing