Tekin Builds Ep. 8 - TLR 8IGHT-X E Electronics Install

This episode covers the electronics installs. An RX8 GEN3, T8 GEN3 and T-250 Servo go in the 8IGHT-X E and Ty also covers some soldering tips, shows how to center and set servo end points (EPAs) and shows how to calibrate the RX8 GEN3. Lastly, setting the proper voltage cutoff is very important so you don’t damage your LiPOs! The RX8 GEN3 has a 2S cutoff out of the box, so if you want to run 3-6S you have to set the proper cutoff. T8 GEN3 Install - 0:54 T-250 Servo Install - 5:34 RX8 GEN3 Install - 7:35 Soldering - 9:28 T-250 Centering - 14:20 Set Servo End Points – 15:04 RX8 GEN3 Setup - 16:25 Radio Calibration - 16:45 Set Voltage Cutoff - 17:50 http://www.teamtekin.com