Voltage regulator with negative feedback (5 - Regulators)
Let's design a voltage regulator with an op-amp, a zener diode, and a pass transistor. Here we discuss how it works. Aaron Danner is a professor in the Department of Electrical and Computer Engineering at the National University of Singapore. https://danner.group Video filmed and edited by Cheryl Lim. @randomcheryl
▶︎
Fully Explained Voltage Regulator Designs (6 - Regulators)
▶︎
What does a voltage regulator do? (1 - Regulators)
▶︎
Resonance Explained: How L and C Cancel, and Why It Matters
▶︎
EEVblog #908 - Zener Diodes
▶︎
Using inductors to bias transistors (30-Transistors)
▶︎
How to Properly Bias a Transistor
▶︎
Voltage regulator short circuit protection (7 - Regulators)
▶︎
Feedback
▶︎
Series Voltage Regulator (4 - Regulators)
▶︎
Differential Amplifiers with Transistors (23-Transistors)
▶︎
DIY - High voltage linear regulator based on the LM317 - Part 1
▶︎
How to use a zener diode (2 - Regulators)
▶︎
Fixing the Full Bridge Rectifier’s Big Flaw - Active Power Factor Correction
▶︎
Probably the most used component nobody knows of! TL431 Guide! EB#50
▶︎
Why is This the Scariest Chart in Electrical Engineering?
▶︎
Voltage Regulator Op Amp Circuit with Foldback current limiting
▶︎
Miller Plateau effect within MOSFETs explained – a simple and intuitive approach
▶︎
Biasing transistors with current sources (29-Transistors)
▶︎
The Power Grid Failure That Almost Took Down Half the Country
▶︎