Reparación de sinfín de dirección asistida hidráulicamente

How to disassemble and assemble a hydraulic power steering worm gear. In this tutorial, you start by holding the auger, then the pinion lock is removed, then the valve with the O-rings, then the oring. The process continues by extracting the upper pin, it is explained: when the pin is worn, the steering becomes very sensitive when driving, it is explained about the lower pin when it is worn, the steering presents many oscillations, when there is wear on said pin it is due replace. Before removing the upper pin, it is recommended to make a mark to prevent it from changing position when it is assembled, then the inner oring is removed, then the O-rings are removed, then the new seals are installed with the help of polyethylene tape, proceed to install the orings, then proceed to install the splined shaft in its correct position, then install the upper pin. Finally, the joints are molded with the help of a horn with a countersunk shape at the end. Continuing with the work, the valve with its O-rings is installed. Visit: http://hidraulicaveloz.blogspot.com/