Ford F-350 OBS 7.3 turbo removal - the ONLY TOOLS that I needed ?!

Ford OBS 7.3 diesel - TURBO REMOVAL - these are the only tools that worked for me ! After several hours of trying to remove the turbo and several trips to local stores to find tools - I would up removing the turbo ( in about 50 minutes ) with only a 1/4” drive compact ratchet with a 6” extension , a 1/4” drive compact 10mm and 15mm compact universal sockets from Matco , a cheap 3/8 drive 15mm crows foot and an 8mm ratcheting wrench. Also used an LED work light to light up the underside of the motor The 1/4 “ drive universal sockets are significantly shorter and thinner than any 3/8” drive universal socket - for me it was the only thing that worked Once I had the right universal sockets the job went relatively smoothly - took about 40-60 minutes to remove the pedestal and turbo ( not counting prep, removal of the Y pipe, wasted trips to hardware stores , watching you tube vids etc !:) One thing I forgot to mention, but if you look close enough you can see the bolt is loose ) I removed one additional 12 point bolt at the top of the iron turbine between the compressor and the turbine to make it easier to get the extension and angle on the bolt at the drivers side lower stud. Hope this helps