Project stock power heatwave…the end! …the descrition below has my parting thoughts on this series 😁

Proboat Heatwave 24v2 Stock motor and esc Sharpened stock rudder Strut set to 4mm Teflonless stuffing tube Smc SRD 6700 2s packs x2 Red 4619 sharpened high rake prop 60mph pb for the boat In conclusion I’ll offer this advice… These boats are pretty enjoyable out the box, If I had one mod to tell everyone to do, it would be to upgrade your transmitter. The Radiolink rc4 and rc6gs units are cheap and offer basically 4 times the range of the stock system. You will enjoy the boat more not worrying about running out of range. Performance wise I’m pretty sure I covered anything we could here. Most guys will just try a few after market props. Without a doubt, the best all around prop you can run on this boat is the red 44mm 1.9 high rake props, or what we refers to as the 4419. It will get your speeds well into the 50s and temps and low voltage cuts will be manageable. Batteries I still think the SMC 6700 hard case packs are impossible to beat. We got 60mph with this boat using a very well used pair. Any of the SMC line are top tier. If your on a budget get some smc hcl-ec 5200 packs, at $20 each they will outperform anything you can get on Amazon or eBay. I hope you guys enjoyed this series, I know it was long, but being thorough is sometimes tedious and boring 😂 Thanks to the OG boat gang crew and all the guys new to the channel and hobby for following along! 👍🏻 Have a great one guys and see you soon! Trey and Trey 👊🏻👊🏻