Foxbody Megasquirt Installation Guide

Matthew takes you through the full process of installing the Megasquirt Plug and Play engine management system on a Foxbody Mustang including preparation, removing the old engine management, the physical install, vacuum setup, initial software setup, base timing, startup, and through to a dyno pass. It's a long video, but is chaptered for your convenience. Tecmotion Store: https://tecmotion.etsy.com Chapters 00:00 Introduction 00:30 Discussion of PCM Options 03:08 Check for Pre-Existing Problems 06:15 Diagnose TPS Fault 11:48 Unbox MS2PNP 14:35 Jumper Settings 17:35 Battery Disconnect 18:07 Remove PCM from Car 21:52 PCM Installation 24:15 Vacuum Routing and Repairs 28:20 Summary of Physical Install 29:45 Tuning Project Setup 32:15 TPS Calibration 33:10 Initial Tuning Setup 37:10 Startup 37:55 Adjust Base Timing 39:35 Installation Summary 41:55 Lincoln Mark VII Notes 42:35 Dyno Pull