13- How to Connect Two Delta PLCs Using Ethernet

In this video, I will show you how to connect two Delta PLCs together using Ethernet cables instead of the traditional RS485 method. I will be demonstrating a powerful feature called "Data Exchange" to achieve high-speed and reliable data sharing between devices. I will guide you through the hardware wiring process using a network switch, then move on to programming both the "Master" and "Slave" PLCs using ISPSoft. Additionally, I’ll show you how to configure a Delta HMI to control the entire system and explain how to use DCISoft to enable automatic data exchange, ensuring your connection remains active even after a power cycle. ___________________________________ 00:00 Introduction to connecting Delta PLCs via Ethernet. 01:19 Hardware setup and wiring using a network switch. 02:22 Alternative wiring options (Combining Ethernet and RS-485). 05:07 Starting ISPSoft programming for the Master PLC. 06:04 Communication settings (Commgr) and network device discovery. 08:43 Programming the Delta HMI to control the Master PLC. 11:27 Programming the Slave PLC and changing its IP address. 12:21 Using DCISoft to modify network and device parameters. 15:47 Activating the Data Exchange feature between PLCs. 18:26 Practical test: Transferring numerical values (Words) between units. 19:01 How to transfer Bits and Markers using Move commands. 22:50 Displaying and monitoring Slave PLC data on the HMI screen. 25:46 Conclusion and final wrap-up. ___________________________________ LinkedIn:   / hendawy88   ___________________________________ #Delta_PLC #ISPSoft #WPLSoft #DirectLink #PLC_Delta_Advanced #PLC_Programming_Arabic #Industrial_Automation #Delta_Electronics