HappyModel Mobula7 HD review part 2 - setup, receiver binding and Caddx settings

The Mobula 7 is one of the best 2S tiny whoops around and the HD takes it to the next level by turning it into a cinewhoop. The larger motors give you extra power to carry the built in Caddx Turtle V2 HD camera, allowing you to record high quality footage to show off on youtube. In this video I review I'll show you how to bind the receiver in D8 mode, the betaflight setup and my Caddx settings for best footage. Happymodel Mobula7 HD https://bit.ly/2Tt8ft6 Happymodel Mobula7 https://bit.ly/2SXnoP6 Taranis X9D Plus SE https://bit.ly/2JGndaL FrSky XM+ Receiver https://bit.ly/2CdMId9 Here's the full spec: New Crazybee F4 PRO V2.0 AIO Flight controller 1-3s Lipo Compatible 2S for indoor Cine whoop mode 3S for outdoor Freestyle whoop mode Betaflight support , multi flight mode: ACRO/AIR/ANGLE The lightest 1102 brushless motor only 2.7g with double ball bearings Powerful and smoothly Betaflight OSD support ,easy to get RSSI, Voltage ,current from your goggles(DSMX version no RSSI output) Caddx turtle v2 + 1080p 60fps DVR ready Camera Angle adjustable VTX power switchable 25mw~200mw Smartaudio ready , change VTX bands, powers, channels via OSD Frsky Non-EU version support NON-EU Frsky transmitter D8/D16 compatible Flysky version support both AFHDS and AFHDS-2A protocol transmitter DSM2/DSMX version support DSM2 and DSMX compatible Spektrum transmitter No RX version support external serial-bus receiver like xm+, crossfire, S-FHSS etc.. Full telemetry function ready (Frsky Non-EU and Flysky version support) Special Breath light ready Real Bind and Fly version Compatible both for 2s-3s Lipo/LIHV #whirlybloke #fpv #mobula7 #happymodel