8.2" 10 Bolt BOP (Buick, Olds, Pontiac) axle bearing replacement.
Replacing the bearings on my BOP 10 bolt axle. Used Timken Set9 bearings and Yukon grease seal. Next video will be on replacing the open diff with 2.79 gears for a Yukon Posi with 3.55. I hope this video was helpful for you guys. Let me know if you have any questions. Or any experts out there that seen me do something wrong let me know that too. Thanks
▶︎
🔋Never Buy Drill Batteries Again! Use a Rivet and Watch What Happens!😱
▶︎
Tech Tuesday: How to Replace Your Old Axle Bearing
▶︎
Oldsmobile Part 8 - Converting the 10 bolt rear end to Posi with new gears - Part 2
▶︎
Axle Repair Bearing Installation - Chevy C10
▶︎
I ALMOST DESTROYED THIS FRESH ENGINE BUILD
▶︎
How to PROPERLY Replace Trailer Wheel Bearings
▶︎
How To Build Chevy 10 Bolt And 12 Bolt Rear End - START TO FINISH
▶︎
The 90-Degree Torque Problem
▶︎
400 + horsepower GM 8.2 10 bolt complete how to video
▶︎
How to replace a rear axle shaft bearing and seal on a Jeep TJ or LJ Dana 44
▶︎
Stihl 031AV electronic module upgrade and timing adjustment.
▶︎
Which Traction Device is Right for You?
▶︎
How To: Replace the rear wheel bearings on a 1955, 1956, 1957 - 1964 Chevy. Trifive axel bearings
▶︎
How to Replace a Clutch in your Car or Truck (Full DIY Guide)
▶︎
How To Repair Axle Bearings On GM 10-Bolt Rearends
▶︎
Dangerous Grindstone Installation in 1971
▶︎
Mountains Garage: 8.2 GM 10 Bolt Rear End Assembly
▶︎
1970 PONTIAC LEMANS/GTO AXLE BEARING REMOVAL
▶︎
The Insane Genius of a Formula 1 Gearbox
▶︎