Design a Fender Flare in Fusion 360 - Adding Detail Lines to Control Shape and Flow

In this video we are FINALLY at the point where we can begin to add some more control edges where we want to get a bit more shape or character. We are getting close to finishing off this design and we are finally able to use Pull to move some vertices before adding more control edges. This is a critical phase in the design. You must make sure you don't have too many control edges/faces on the design and that you pull it to the mesh before adding more edges or else it will be much harder to control. Be sure to ask questions in the comments if something doesn't make sense. Remember this is a raw look at the design decision process so it takes a bit of time but hopefully is valuable.