RC Airplane Build Stand

We have officially started building the Carbon Cub 15cc and, anticipating some upcoming steps in the manual, we needed a build stand!! So we decided to just make one out of PVC pipe, some fittings, and a little creativity. We followed a picture/build post from RC Universe but we changed a couple things slightly dimension-wise. We will post the original link below and also list the changes we made. We have about $20 into this stand, so for our purposes it's perfect, cheap, and we didn't have to wait for anything to come in the mail!! Original Build Stand - https://www.rcuniverse.com/articles/h... What we changed/used - added a "V" at the top by using a 3 way 90 degree joint on each end used 1/2" PVC (plenty strong) instead of the 1" from the original design "V" arms 7 1/2" long (4) leg extensions 5 1/2" long (4) connector pieces 1 1/2" (8) cross bars 20" long (2) T fitting's. (6) 90 degree fittings (6) 3 way 90 degree corner (2) plug ends (4) caps (4) 1/2" foam insulation wrap (1 section) In hindsight, we would not have used the caps on top of the V arms but used plug ends instead. The caps bulge the foam out too much and don't add any benefit. The plugs would be a much cleaner look up top. We originally used 1/2" foam insulation but 3/4" probably would have been better fit. We will probably change to them! Good luck, have fun! *VIDEO GEAR WE USE* GoPro HERO 7 Black - https://amzn.to/3wjCP8x Neewer On-Camera Video Mic - https://amzn.to/3kaRj5N *THANK YOU FOR SUPPORTING OUR CHANNEL!!* When you purchase through our affiliate links from Amazon and other sites, we may earn a small commission at no additional cost to you. This allows us to provide more valuable content to you, our awesome audience! If you would like to donate and help us with our ever-increasing glue supply 😜 - https://paypal.me/ungluedmodeler You can also find us randomly lurking on Instagram –   / ungluedmodeler   #ungluedmodeler #rcplanestand #pvcdiy