SnapMaker 2.0 Dual Extrusion Module: Unboxing & Setup. IT'S HERE!

#3dprinting #snapmaker #unboxing #setup After pre-ordering this in September 2022, it has finally arrived! The Dual extrusion module is an update that i have been really looking forward to! Wanting to experiment with multi-material prints and special support materials? Then dual extrusion looks like the perfect way forward. In this video i cover an unboxing of the new SnapMaker 2.0 dual extrusion module. I also install it and run through the dual extruder calibration settings. I also get a dual tone print in action and have a look over its quality! If you are installing this yourself, be sure to read the instructions thoroughly (unlike me). The 2 Colour Tree Frog i used was a design from Nervoussystem and is Available on Thingiverse: https://www.thingiverse.com/thing:329436 This was a rather rushed video as i had no expectations as to when the 3D printing dual extruder would arrive, but i have tried to cover as much as i can in the day I've had. I have been unwell but as soon as i get some requests i will be putting together another video with PVA water soluble support filament, instead of the PLA break away support material. I also will be using this module to print LW-PLA and PLA+ mixed components for my homemade EDF spy plane. As well as using high temperature prints such as carbon fiber nylon (CF-PA) (and PVA supports) to complete some automotive projects, comparing them to my modified extruder. Do get in touch if you would like to see me try anything else with this beast!